Anti-slip Film Faced Plywood veneer seam problems and production methods from buzai232's blog

Anti-slip Film Faced Plywood veneer seam problems and production methods

In daily life, we often come into contact with Anti-slip Film Faced Plywood. Many people do not know about plywood. What is plywood? According to the introduction of plywood manufacturers, plywood is cut into veneer from wood segments or by planed wood. It is a three-layer or multi-layer plate-like material that is cut into thin wood and glued with adhesive. Generally, odd-numbered veneers are used, and the fiber directions of adjacent layers of veneers are glued perpendicular to each other.To get more news about commercial plywood, you can visit boosterplywood.com official website.

Anti-slip Film Faced Plywood is one of the commonly used materials for furniture. It is one of the three major panels of wood-based panels. It can also be used for aircraft, ships, trains, cars, buildings and packaging boxes. A group of veneers are generally divided into adjacent layers The wood grain directions are perpendicular to each other and the blanks are glued together. Generally, the surface board and the inner layer board are symmetrically arranged on the two ends of the center layer or the board core. Constrained under the condition of heating or non-heating, the number of layers is generally odd, a few are even, and the physical and mechanical properties of the vertical and horizontal directions are relatively small.

The commonly used types of Anti-slip Film Faced Plywood are three plywood, five plywood, etc. Plywood can improve the efficiency of wood and plywood, which is an important way to save wood.

Today's furniture boards, due to the different sizes of logs, sometimes need to be spliced. Today, let Anti-slip Film Faced Plywood manufacturers introduce to us the problems and solutions when splicing plywood.

One is that it is found to be too tight or too loose after sewing. This problem is mainly caused by improper adjustment of the feeding and tightening roller of the sewing machine. In such a situation, we only need to adjust the work surface of the sewing machine. The next pair of tapered squeeze rollers to fit.

The second kind that often occurs is that the ends of the veneer that are spelled out are uneven. This situation is mainly caused by the improper operation of the seam. When feeding on the machine with glue in the longitudinal direction, the ends of the two veneers are not aligned or single. If the board is not formed into a rectangle when the edges are aligned, it is necessary to know that there should be a datum when the veneer is aligned, and the veneer cannot be cut into a parallelogram.

The third situation is that the adhesive tape is not firmly attached after the Anti-slip Film Faced Plywood is spliced, resulting in not being strong. This happens because the adhesive tape is not sufficiently wet, and the temperature of the heating roller of the plywood manufacturer's seaming machine is too high or too low. The pressure of the upper roll is not enough. The treatment method is simple, and the tape can be fully wetted with water, check the heating roll, and increase the pressing force of the upper roll.