How to Install LED Neon Rope Lights? from buzai232's blog

How to Install LED Neon Rope Lights?

Measure out and cut the rope light to the required length. The maximum run for 120V neon rope light is 150 feet; if you have a longer run, you will need additional power supplies. Only make cuts along the cut lines marked on the PVC insulation every 18 inches. Cutting outside of these lines will cause that section not to light. The rope light comes with four power pins, four end caps, eight 4-inch sections of shrink tube, and a power cord. If splicing two colors together, cut each at a cut line, then connect using one of the power pins. Slide the section of shrink tube over the connection and heat so that it seals the connection. The pins are not flexible, so only make connections where you don’t need a tight curve. Use an end cap to cover the end of the rope light not connected to the power supply and on the other end, secure the power adapter. Install the mounting clips or tracks, then gently push the rope light into the track until it clicks in place.To get more news about neon light strip, you can visit htj-led.com official website.

LED neon rope light is only flexible against a flat surface. While it has a very narrow bend radius for side-to-side curves, it should not be twisted or bent in an arch or dip that would bend the top or back of the rope light as this may damage the LEDs. It should also not be suspended unsupported or installed on gates or doors where it’s susceptible to frequent flexing and movement.

Don’t turn on the rope light while on the spool. LEDs put out less heat than other technologies, but when tightly coiled, the heat has nowhere to go and can ignite the PVC sleeve.

When installing parallel runs, don’t install them closer than half an inch apart. This may cause the rope light to overheat, shortening its lifespan.

Do not submerge the rope light under water. If you want something to line your pool, consider purchasing underwater tape light instead. LED flexible neon rope light is only designed for heavy rain, not for total submersion.