How to properly commission a small roller from quangongzi's blog

In order to achieve our results we will use a small roller in the road laying, because the speed of small rollers we need to debug, today's small road roller manufacturers to teach you how to debug small roller. Commissioning without the need to feed, but must first guide the board to guide the screw up, and then use the way to punch the hammer slowly transferred to the bottom dead center, at the same time ...

 In order to achieve our results we will use a small roller in the road laying, because the speed of small rollers we need to debug, today's small road roller manufacturers to teach you how to debug small roller.Road Repair Machines

Commissioning without the need to feed, but must first guide the board to guide the screw up, and then use the way to punch the hammer slowly transferred to the bottom dead center, and must pay special attention to the guide plate can not be floating rod too Low, otherwise it will cause the floating rod to bend or break. When punching is done continuously, the speed adjustment screw of the feeder must be rotated in a clockwise direction, and the slider movement is slightly slower so that it can see if the slider is moved against the nylon gasket and the length trimmer. When the test machine when the slider moves back and forth, if only encountered nylon gasket did not touch the length of the fine-tuning screw, which is floating pole down deep enough, need to punch the boot screw slowly down. If the slider moves back and forth, the metal leveling machine only touches the length of the trimmer screw does not touch the nylon gasket, which is the floating rod down too deep, need to punch the boot screw slowly upward.

Daan Machinery hope that through the above description of your use of small roller have some help, our company is a professional small roller manufacturer, the company since its inception has accumulated a wealth of experience and professional knowledge, you are welcome to come to buy.